e-Secret Keeper Paracord Cover: How to Conceal an E-Collar Receiver
By E-Collar Technologies | Published: 2026-11-04
Category: 操作指南
Learn how to hide an e-collar on your dog with the e-Secret Keeper Paracord cover. Step-by-step fitting, care, and common mistakes for a low-profile training setup.
Quick answer
Use the e-Secret Keeper Paracord cover to hide the receiver on a compatible e-collar strap, then check fit and skin clearance before every session. The cover works best when the receiver is fully enclosed and the strap sits snug but not tight.
When concealment helps and when it does not
A low-profile setup matters most for hunters, field trainers, and anyone who wants training gear to blend into everyday walks. The e-Secret Keeper Paracord cover is built for that job, but it is not a substitute for proper receiver placement or a secure strap.
Concealment can slightly change how quickly you can reach the receiver or check its indicator light. If you rely on frequent visual checks during training, plan a routine that lets you confirm status without removing the cover each time.
Compatibility and fit limits to know
The cover is compatible with select e-collar receivers, so confirm your receiver model before ordering. Because the catalog does not list dimensions or a full compatibility list, measure your receiver and strap width and compare with the cover's opening rather than guessing.
Paracord construction gives a durable, understated look, but it is not waterproof padding. In wet or muddy conditions, expect the cord to hold moisture and plan to dry it thoroughly before storage.
How to fit and care for the e-Secret Keeper cover
- Match the cover to your receiver: Slide the receiver into the e-Secret Keeper Paracord cover before attaching anything to the dog. The receiver should sit fully inside with no exposed contact points and no need to force it through the opening. If the receiver does not seat easily, stop and confirm compatibility rather than stretching the paracord.
- Mount the cover on the collar strap: Thread the e-collar strap through the cover's intended pass-through so the receiver sits flat against the strap. Keep the cover centered where the receiver normally rests. A cover that twists or bunches on the strap will rub; rethread it until it lies flat.
- Check strap tension and skin clearance: Fit the collar so you can slide two fingers under the strap at the receiver location. The cover adds bulk, so recheck tension after mounting rather than assuming the old setting still fits. If the cover presses the receiver harder into the skin, loosen the strap one notch and retest.
- Test the setup during a short session: Put the dog on a leash and watch for slipping, rotation, or chewing at the cover during a five-minute walk. Confirm the receiver still responds to the transmitter before you rely on it in the field. Any rotation that moves the receiver off its intended position means the fit needs adjustment before real training.
- Dry and inspect after wet or dirty use: After rain, mud, or a swim, rinse the paracord with fresh water if needed, blot it, and air-dry it fully away from direct heat. Check the cord for fraying or loose ends at the same time. Storing the cover damp can weaken the cord and trap odor; dry it completely before it goes back on the collar.
Product facts
- e-Secret Keeper Paracord e-collar cover: The e-Secret Keeper Paracord e-collar cover is designed to help keep your dog training e-collar discreet. It gives you a dedicated concealment layer instead of wrapping the receiver in tape or fabric that can slip.
e-Secret Keeper Paracord e-collar cover - e-Secret Keeper Paracord e-collar cover: Paracord construction provides a durable, understated look. The woven cord resists everyday wear while keeping the setup visually low-key on walks or in the field.
- e-Secret Keeper Paracord e-collar cover: It is compatible with select e-collar receivers to help conceal the device. Check your receiver model first; a loose or forced fit can let the cover shift during activity.
